Sonnen sonnenBatterie eco 8.0/10, Руководство по эксплуатации

Страница: 10 / 36

3 | Product description
10 / 36 Operating instructions sonnenBatterie eco 8.0
Degree of Protection IP30
Rated short-withstand cur-
rent(I
CW
)
10 kA
Separation principle PV -> AC -
Separation principle Batt. -> AC galvanic isolation (functional insulation)
Power meter
Voltage measurement inputs Nominal voltage (AC): 230 V (L-N), 400 V (L-L) | max. connectible conductor
cross-section: 1.5 mm²
Clamp-on current transformer Max. measurable current: 60 A (standard), optional up to 400 A
Ambient conditions
Environment Indoor (conditional)
Operating temperature range
1
-5 °C ... 45 °C
Storage temperature range 0 °C ... 40 °C
Transport temperature range -15°C ... 50 °C
Max. rel. humidity 90 %, non-condensing
Permissible installation altitude 2,000 m above sea level
Pollution degree 2
Additional ambient conditions:
• The installation location must not be at risk of flooding.
• Installation room should be ventilated.
• The currently applicable building codes must be observed.
• Even floor, suitable for heavy loads.
• Observe fire control standards.
• Free from corrosive and explosive gases (ammonia content max. 20 ppm).
• Free from dust (especially flour dust or sawdust).
• Free from vibrations.
• Free access to the installation location.
• No direct sunlight.
3.2 Type plate
The type plate for the storage system is located on the outer surface of the system. The
type plate can be used to uniquely identify the storage system. The information on the type
plate is required for the safe use of the system and for service matters.
The following information is specified on the type plate:
• Item designation
• Item number
• Technical data of the storage system
1
Optimal: 5 °C … 30 °C | Derating possible below 5 °C / above 30 °C.