Sonifex AVN-MPPR, Руководство пользователя

Страница: 18 / 48

10
3 AVN-MPPR Presenter Remote Unit
10
4 AVN-MPTR Technician Remote Unit
Reset button
The recessed reset button at the bottom left corner of the front panel
triggers a hardware reset of the unit
IP address reset
As well as being able to set the IP address of the unit via the web pages, it is
also possible to reset the IP address of the unit from the front panel to a
factory default. To carry out the reset, press and hold the GPO button and
rotary control D while the unit is booting up. This will take roughly 10
seconds. When the IP address is reset, the Ethernet LED will be illuminated
Yellow and all 4 encoders and the GPO button will flash yellow for around 5
seconds. The unit will then reboot. The IP address of the unit will then be
reset to the factory default of 192.168.0.100.
Rear Panel
The rear panel of the Presenter Unit has three connectors and two controls:
Network Connector
This is a Neutrik etherCON RJ45 CAT5e connector with latching lock with
PoE plus for unit power
Mix Output Mono Analogue Output
The mix output is a XLR 3 pin XLR male output which is electronically
balanced, which has the following connections:
Standard GPIO Connector
This is a 15-way female ‘D’-type connector with the same pin connects as
for the AVN-PX8x4C Mix Engine.
Pin Number Description
Pin 1 Screen
Pin 2 Phase
Pin 3 Non-phase
Hardware ID Settings
These are two 16 position rotary switches, currently labelled ID1 Group and
ID2. ID1 (Group) rotary switch selects the group assignment for the MPPR
and is used by the Mix Engine when determining which MPPRs to grab and
authorise. Currently ID 2 is unused, but it may be necessary to use this
selection to extend the ID1 allocation if the number of group selections
exceeds 16.
Mounting the AVN-MPPR Presenter Remote Unit
There are two mounting methods:
The AVN-MPDB Presenter controller desk mount
bracket allows the Unit to be mounted either way
up on the underside or top side of a desk.
The AVN-MPMB Presenter controller desk mount
is a bracket that mounts to the underside of the
Unit and allows it to be fixed to the top of a 3/8”
Whitworth microphone stand screw socket. It has
adjustments in various planes to allow it to be
suitably positioned in front of, or to the side of, a
Presenter.
Fig 3-3: AVN-MPDB
Presenter Controller Desk
Mount Bracket