Installation and setup for the HA360DB
HomeAware™ Doorbell Signaler
The HA360DB Doorbell Signaler will alert you when someone comes to visit. The HA360DB
requires no wires and can be installed in seconds.
The HA360DB will alert you to someone at the door via the HA360M master unit. The master
unit receives a wireless signal from the Doorbell signaler and will flash a strobe, make a loud
sound and vibrate a bed shaker. Once the master unit receives the signal from the doorbell it
will also send a signal to all HomeAware remote receivers. In addition to the HomeAware
receivers, if using our optional bridge unit you will also be alerted to the HA360DB doorbell
signaler using your original Sonic Alert receivers (SA102, SA201, BL300, and SB1000).
Step #1) Install Battery
The HA360DB comes with two #357 silver oxide long lasting batteries that need to be
installed into the bottom of the unit. See photo for Battery installation. Once installed the red
light should light when the button is pushed. If the light does not show, you may have the
batteries in backwards.
Step #2) Installation of button outside
There are two methods for installing the doorbell button, see #3 if you have an existing
doorbell chime box.
For this method you will need the provided hardware to install. We provide screws, and a
mounting block see diagram for button install below, also step by step instructions.
To install to a hard surface using the provided hardware follow these steps:
1) Install mounting block using provided short screw. Install the small side to the surface
(side without arrow). This will provide a space for the unit to slide over in order to attach
to the mounting block.
2) Remove the screw cover at the top of the doorbell unit; this will slide up to remove. Once
removed, you’ll see the top screw mounting hole.
