User Manual for the Type 8370
WSM 6+ Transponder
UM-8370
Issue A Rev 1
24
c. On the
Baud Rate
combo box, Type
1200
and then click
Connect
.
1. On the
Manual Commands
tab type
@
in the text box and then click
Send
. The WSM 6+
should transmit an audible navigation pulse.
2. Using the steps described above, change the baud rate back to its original value (default
9600
).
3. Restore the power and navigation settings back to the desired operational values.
7.4.4 Sensor Test
Use either of the two following procedures to test the sensors on the WSM 6+:
7.4.4.1 6G Terminal Lite
Refer to
6G Terminal Lite, Section “Sensors Test”
.
7.4.4.2 iWAND Hand Held Test Unit
Refer to
UM-8315 “User Manual for the Type 8315 iWAND”
,
Section “View Sensors”.
7.4.5 Release Test
Use either of the two following procedures to test the release mechanism on the WSM 6+:
7.4.5.1 6G Terminal Lite
Refer to
6G Terminal Lite, Section “Test Release”
.
7.4.5.2 iWAND Hand Held Test Unit
Refer to
UM-8315 “User Manual for the Type 8315 iWAND”
,
Section “View Sensors”.
7.4.6 Battery Check
Refer to
6G Terminal Lite, Section “6G Setup”.
The battery voltage is displayed on the
Identity
pane.
7.4.7 Firmware Update
The WSM 6+ is capable of accepting firmware updates from a PC, via the Type 8370-011-01/02
WSM 6+ charger/comms interface, eliminating the need to dismantle the transponder.
