The
SOLIRIS receiver RTS
is a radio receiver for awnings with an auto-
matic control according to the daylight intensity and protection against
wind damage.
The
SOLIRIS receiver RTS
has to be used with the
TELIS soliris RTS
and
the
SOLIRIS sensor
.
The
SOLIRIS receiver RTS
is also compatible with the other
RTS controls
and the
INIS RT
(
the functioning is a trip switch type :
▲
, stop,
▼
, stop,…)
Commands are transmitted by radio (frequency 433.42 MHz).
®
❏
Mains supply : 220-240 V~ 50/60 Hz
❏
Protection index: IP 44
❏
Operating temperature: -20°C to +50°C
❏
Class II product once installed
❏
Normally polluted environment
inteo
SOLIRIS receiver RTS
INSTALLATION
guide
Ref.182249A
Characteristics:
Installation:
2
108 mm
108 mm
Before connecting the unit, you must read the instructions carefully.
N
N
L
▲ ▼
SC
MAIN
SUPPLY
Earth
Phase
Neutral
Soliris receiver RTS
LT motor
N
Soliris sensor
SC
SC
= Main phase
= Main neutral
= Motor neutral
= Motor up
= Motor down
= SUN input
= WIND input
= COMMON input
N
N
L
▲
▼
58 mm
150 mm
1
Mounting of the SOLIRIS receiver RTS :
A
The SOLIRIS receiver RTS is compatible with all standard SOMFY
motors. Cabling arrangements are shown in the diagram.
Respect the electrical standards in force as well as the following points:
❏
disconnect the mains before carrying out any work.
❏
Install the SOLIRIS receiver RTS with the cables entry pointing downwards
to avoid water infiltration.
❏
Do no install the SOLIRIS receiver RTS against a metallic part
(it could affect the radio transmission).
❏
minimum distance between the receiver and the floor :
1,5 m
.
❏
minimum distance between the receiver and the roof :
30 cm
.
❏
minimum distance between the receiver and the transmitter :
30 cm
.
❏
minimum distance between two receivers :
20 cm
.
wind led
prog button
prog led
sun led
wind
potentiometer
sun
potentiometer
manual
control button