1
FACTORY MODE
BEFORE YOU BEGIN
Motors are shipped in FACTORY MODE without limit settings and the
transmitter ID’s. Power must ONLY be connected to current screen
being programmed. All other screens must be disconnected from their
respective power while programming.
Note - If motor is 120V AC hardwired and cannot be disconnected,
please contact an electrician prior to calling Somfy customer service
for assistance.
QUICK PROGRAMMING GUIDE FOR
MAESTRIA™ 50 RTS MOTORS
CONNECT TO POWER MODE
With the motor installed in the screen, connect power to the motor (120V AC).
While programming, screens should not be inactive for longer than 2 minutes
or motor will exit PROGRAMMING MODE.
Side View
50mm motor diameter
INITIATE PROGRAMMING
On the transmitter, press and hold both UP and DOWN
simultaneously until the screen jogs.
CHECK THE DIRECTION OF OPERATION
If hand-held transmitter direction is not properly programmed,
Eolis/Soliris RTS sensor will not function in the manner it was
intended. Damage to the screens and injury may occur as a result.
Check the direction of rotation by pressing
UP or DOWN.
If necessary change the direction of rotation
by simply
pressing and holding the MY
button until the screen jogs.
MAESTRIA™ 50 RTS
MOTORIZATION FOR EXTERIOR SCREENS
