Characteristics :
The TELIS SOLIRIS RTS is a SINGLE CHANNEL hand-held transmitter
compatible with the SOLIRIS receiver RTS
Commands are transmitted by radio (frequency 433.42 MHz).
❏
Power: 3V lithium battery, CR 2430 type
❏
Protection index: IP 30
❏
Operating temperature: +5°C to +40°C
❏
Class III product
❏
Normally polluted environment
Programming :
• Press the PROG button of the SOLIRIS receiver RTS until its LED lights. This indicates that the receiver
is ready for one minute to memorise the address of the transmitter. After this time limit, the LED goes out.
• Press the programming button on the backside of the TELIS SOLIRIS RTS with a ball-
point pen until the LED of the SOLIRIS receiver RTS blinks.
➭
The address of the transmitter is memorized by the RTS receiver which automati-
cally quits its programming mode.
INITIAL INSTALLATION
inteo
TELIS SOLIRIS RTS
I N S TA L L AT I O N
g u i d e
1
A
2
Memorise a TELIS SOLIRIS RTS in the memory of a SOLIRIS receiver RT S
TWO POSSIBILITIES
1
Repeat the same procedure as described in chapter 2A.
2
• Press more than two seconds on the programming button of a TELIS SOLIRIS RTS already memorized in
the SOLIRIS receiver
RTS in order to “wake up” the receiver.
➭
the both LEDs of the TELIS SOLIRIS RTS light on, indicating that the SOLIRIS receiver RTS is in
its programming modefor one minute.
• Press b r i e f l y the programming button of the new control you wish to memorise.
➭
The address of the control is memorised in the SOLIRIS receiver RTS which automatically quit its
programming mode.
EXISTING INSTALLATION
B
Add another control (TELIS 1/4 RTS; CENTRALIS RTS ) in the memory of the SOLIRIS receiver RT S
120 mm
45 mm
17 mm
51 mm
23 mm
102 mm
Hereby, SOMFY, declares that this equipment is in compliance with the
essential requirements and other relevant provisions of Directive
1999/5/EC.
A Declaration of Conformity is available at the web address
www.somfy.com
Heading
CE
