The EOLIS sensor RTS is a radio sensor for awnings with a protec-
tion against wind damage.
The wind threshold can be set directly on the EOLIS sensor RTS.
The EOLIS sensor RTS has to be used with the OREA RTS and
ALTUS RTS motors.
Mains supply : 220-240 V~ 50/60 Hz
Protection index : IP34
(cable bushing not drilled. Only guaranted if professionally
installed).
Operating temperature : -20°C to +50°C
Class II product once installed
inteo
EOLIS sensor RTS
INSTALLATION
g u i d e
Installation:
1
Press more than 2
s e c o n d s on the pro-
gramming button of a
RTS control which is
already memorized in the
m o t o r.
(please refer to the installation
guide of the concerned motor).
Press briefly o n
the “prog” button
of the EOLIS
sensor RTS.
➜
Connect the cable
to the terminal.
Put the
cover
Fix the sensor
to the wall.
Put and screw
the front box.
>2 sec.
The motor must be in its learning mode to record an EOLIS sensor RTS.
Up to three EOLIS sensors RTS can be memorized in a motor and one EOLIS sensor RTS can be memorized in seve-
ral motors.
Programming:
2
Characteristics
Mounting
Cabling
The awning moves
shortly (DOWN/UP).
the motor is in “learning”
m o d e .
Enter the “learning” mode
Record or delete a sensor
The awning moves shortly
( D O W N / U P ) .
If it is a new sensor : it will be recorded in the
m o t o r.
If the sensor was already recorded : it will be era -
s e d .
Press more than 7
s e c . on the “prog” but-
ton of the new EOLIS
sensor RTS.
Erase all the sensors and record a new one
The awning moves shortly
( D O W N / U P ) .
the memory of the receiver is cleared
(all the previous sensors are erased)
and the new sensor is recorded.
>7 sec.
➜
➜
Hereby, SOMFY, declares that this equipment is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
A Declaration of Conformity is available at the web address
www.somfy.com
Heading
CE
