Somatik Labs SLS-UV10W, Руководство пользователя

Страница: 9 / 20

7
7.0 HOW TO USE YOUR SLS-UV10W
1. Plug the small end of the supplied USB type C
cable into the device DC power input.
2. Plug the large USB-A end of the charging
cable into a 5V/2A USB-A wall charger or
computer USB port (charger not included).
3. The charging LED will be red and then will turn
off when the wand is fully charged.
NOTE: It is advised to fully charge the
wand before use. A full charge will take
approximately 1.5 hours.
4. Turn ON the wand by moving the switch to the
ON Position.
5. Display will show counter 000.
6. Press the Sanitise/Mode Button and the
counter will change to 060s indicating Single
Clean Mode.
Press the mode button again and the counter
will change to 180s indicating Multiple Clean
Mode.
7. UV Sanitising will start immediately as soon as
the wand goes into Single clean or Multiple
Clean Mode.
8. If the Sanitise/Mode Button is pressed in
between Sanitising, the Wand will go into
Stand by mode and cleaning will stop.
PLEASE NOTE
Your SLS-UV10W Wand has an in-built safety
sensor, the device will not emit UV light if the
wand is tilted more than 30 degrees both