background image

 

Page 3 / 17 

 

WARNING ADVICE 

 

  

WARNING: Serious injury or death can be caused if these instructions are not applied!

 

Do not use this product for uses that are different from those for which it has been designed. 
After  removing  the  product  from  its  packaging  ensure  that  it  is  complete  and undamaged; if in doubt, 
immediately contact a qualified electrician. 
Do not leave parts of the packaging within reach of children or incompetent persons. To dispose of the 
packaging and the appliance at the end of its useful life refer to the recycling norms in force in your country. 
Immediately contact a qualified person (authorised dealer or the manufacturer) if the product is dropped or 
knocked to check its correct functioning. 
Do not touch the appliance with wet or humid parts of the body (e.g., hands or feet). 
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory 
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction 
concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with 
the appliance. Cleaning and user maintenance shall not be made by children without supervision. 
The means of disconnection from the supply mains must have a contact separation in all poles and must provide 
full disconnection under overvoltage category III conditions. 
If there is a combustible-fed device (water heater, gas boiler, etc. of the sealed chamber type) in the room 
where the product is to be installed check that the re-circulation of air is sufficient to ensure a good combustion 
for the correct functioning of these devices, precautions must be taken to avoid the back-flow of gases into the 
room from the open flue of gas or other fuel-burning appliances. 
To avoid the risk of fire do not using the product in the presence of  inflammable 
substances and vapours, such as alcohol, insecticides, petrol, etc. 
The product can be connected to the supply mains only if the voltage and the frequency of the supply mains 
correspond to those written in the rating label. 
In the case of malfunction, anomaly or any type of fault disconnect the appliance from the electrical main 
supply and contact a qualified person. Use only original spare parts for repairs. 
The electrical system to which the appliance is connected must conform with the local norms in force regarding 
electrical systems. 
The appliance must not be used to activate water heaters, room heaters,  etc. 
DO NOT INSTALL ON THE CEILLING. 
 

WARNING: Damage can be caused to the device if the following instructions are not applied! 

 
Do not use the product at environmental temperatures more than  40°C. 
Do not leave the appliance exposed to atmospheric agents (rain, sun, snow, etc.). The possible applications of 
this product are illustrated in this  manual. 
Do not submerge the equipment or any of its parts in water or other fluids, unless specifically required by 
maintenance operations. 
When cleaning or carrying out ordinary maintenance, check the integrity of the appliance. 
The flow of air or fumes that is conveyed by the appliance must be clean and free of greasy elements, soot, 
chemical/corrosive agents and inflammable or explosive mixtures. 
Do not obstruct the air inlet and outlet of the appliance in any way whatsoever.  
When using air ducting make sure that the ducting is not  blocked. 
For an optimum functioning of the appliance, it is necessary to ensure an adequate re-circulation  of  air  in  the 
room.  Consult  the  local  norms  with  regards  to  this. 

 

 

Содержание elicent REC-Duo 100


















Отзывы: