SOLTEK SL-75DRV5, Руководство пользователя, Страница: 17 / 102

17
Chapter 2 Hardware Setup
Installing DIMM
• Make sure you have the correct memory module type for your mainboard.
• Insert the module(s) as shown below, DIMMs have 184-pins and one
notch that will be matched by the onboard DIMM slot. Memory modules
are installed by inserting them straight into the slot until they “click” in the
right place. They only fit in one direction, so do not force them in by a
wrong direction.
184-Pin DIMM Notch Key Definitions(2.5V)
DRAM Key Position Voltage Key Position
2.5V
2-2 Memory Installation
Removing DIMM
• Press down the holding clips on both sides of a DIMM slot and the module
will be released from it.
• Make sure to unplug your power supply before adding or removing
memory modules or other system components. Failure to do so may cause
severe damage to both your mainboard and expansion cards.
• Be careful when inserting or removing DIMM. Forcing a DIMM in or
out of a slot improperly may damage the memory module or the slot.
Some DIMMs which contain EDO or FTP DRAM are incompliant with
the mainboard. The M/B supports 2.5V true DDR SDRAM DIMMs only.