22
B7A-F
PCI 1
DIMM1
IDE1
IDE2
ICS 1893
AGP1 8X/4X
PW1
PW2
Main Power
BIOS
RTL
ALC650
USB3
1
Fan2
PS/2
Mouse
(on top)
DIMM2
nVIDIA
DDR 333/266 MHz
Codec
AC'97
1
Li
Battery
FDC1
FW803
1394A
W83627HF
LPC I/O
PS/2 K/B
(underside)
USB1
Fan1
RJ45
(on top)
Line in
(on top)
COM1
VGA1
(on top)
Mic
(underside)
Line Out
(middle)
IE
E
E
3
1
JAUD1
1
CD_IN1
1
1
P
N
T
1
Fan3
1
HDD
IR
P
WR
20
SPK
RST
+
-
+
-
PWLED
LED
USB2
1
1
JBAT1
1
JUSB1
1
JCLK2
1
JP2
1
JKB1
1
JP3
MCP-T
nVIDIA
nFORCE2
USB1
TV1
VGA2
(on top)
IEEE1
IEEE2
1
JCLK1
COM2
IGP
nFORCE2
RT1
RT2
+12V Power
SOCKET 462
RT2
2-4 IDE Connector Installation
Pin 1 (to Red Line)
IDE2
IDE1
To install IDE Connector, you may connect the blue connector of IDE
cable to the primary (IDE1) or secondary (IDE2) connector on board,
and then connect the gray connector to your slave device and the black
connector to your master device. If you install two hard disks, you must
configure the second drive to Slave mode by setting its jumpers correctly.
Please refer to your hard disk documentation for the jumper settings.
Gray connector
Blue connector
Black connector
Red line
80-conductor IDE Cable
(with Slave Connector)
(To Mainboard)
(To Master Device)
(To slave device)
Blue connector
(To Mainboard)
Black connector
(To Master Device)
Red line
This kind of cable is not recommmended
for the Mini-barebone system because
the ribbon cannot be bundled up and will
block the air flow in the barebone cabinet.
This kind of cable is dedicated for Mini-
barebone system because the ribbon
can be bundled up and will not block
the air flow in the barebone cabinet. A
dedicated cable with a gray connector
for a slave device is an optional item in
the Mini-barebone System.
80-conductor IDE Cable
(dedicated for Barebone)
Bundle Strap
80-conductor
IDE cable
Orient the red line on the
IDE Flat Cable to Pin1.
Hard Disk Drive Connector