Solplanet SOL APOLLO Series, Быстрое руководство по установке

Страница: 5 / 135

IV. EV Charger Mounting
Removing the decorative cover
Inserting the upper mounting
screws
Installing the EV charger on the
wall
Drill three
Φ
10 mm holes at a
depth of approximately 70 mm for
the mounting screws
1. Remove the bottom screw (A) on the flat
workbench.
2. It is recommended to start at the bottom of
enclosure (C) when removing the decorative
cover (B).
1. Install the upper mounting screws (A) in the upper
holes (B). The recommended torque is 4.4 Nm.
2. Ensure the screw protrudes at a length X out from
the wall. The length of X is recommended to be 3
mm (0.12inch).
1. Place the openings (A) over the upper mounting
screws (B).
The upper mounting screws support the EV charger.
1. Hold the installation template (A) against the
wall and ensure the installation is level by using a
spirit level.
2. Mark the location for the three mounting holes
(B).
3. Drill three mounting holes (B).
4. Insert the wall plugs (C) into the mounting
holes (B).
1 2
3 4
ENGLISH 3