Sollae Systems CSW-H85N, Руководство пользователя

Страница: 47 / 83

CSW-H85K User Manual Ver. 2.4
- 46 - http://www.ezTCP.com
5.3 AT Command
In AT command mode, you can control CSW-H85K with AT commands like a controlling
modem. Active and passive TCP connections are available while UDP is not. And you are
allowed to configure some environmental parameters with extended commands.
5.3.1 Key parameters
The configuration should be implemented via the serial port.
Commands Description Examples
+PLIP Local IP Address at+plip=10.1.0.1<CR>
+PLP Local Port at+plp=1470<CR>
+PRIP Peer IP Address at+prip=10.1.0.2<CR>
+PRP Peer Port at+prp=1470<CR>
+PDC DHCP at+pdc=1<CR>
+PTO Timeout at+pto=10<CR>
+WCCT WLAN Topology at+wcct=1<CR>
+WSSID SSID at+wssid= ”sollae” <CR>
+PWP Store setting at+pwp<CR>
Table 5-10 some of extended AT commands for configuration

Related items with an IP address and Local Port
Local port can be set as well as IP address related parameters like IP address, Subnet
Mask and Gateway IP address.

Peer Address / Peer Port
An IP address and local port of a remote host are can be set.

Type of assigning IP address: Manual, DHCP
Not only is manual setting available, but automatic assigning protocol (DHCP).

WLAN parameters
WLAN Topology, SSID and antenna can be configured by the above commands.

Others
Some of options including [Timeout] can be configured in this mode.

Refer to the [AT Command mode] document on our website for details.