CSW-H85K2 User Manual Ver. 1.2
- 30 -
3.2
AT command
In the AT command mode, you can change some parameters through the serial port.
⚫
Requirements
Make sure the connection between your PC and CSW-H85K2 using RS232 cross cable.
To use this mode, CSW-H85K2 has to be set to [AT command] mode on ezManager.
Figure 3-3 setting the communication mode to the AT command
⚫
Procedures
Figure 3-4 configuration procedures with AT commands
⚫
Available settings
Items
Available parameters
IP Address
Local IP Address, DHCP, Subnet Mask, Gateway IP Address and etc.
TCP connection Local Port, Peer Address (IP Address or Host name), and etc.
WLAN
Topology, SSID, WEP, WPA-PSK, WPA2-PSK and etc.
Option
ESC code sending option, timeout and etc.
Table 3-1 available settings by AT command