CIE-M10 User’s Manual Ver. 1.1
Sollae Systems Co., Ltd.
- 48 -
http://www. eztcp.com
Address Automatically”
option
+PSC
To change Serial
Configuration Mode
+PWP
Write parameters to flash
memory
All parameters save in SRAM so user has
to use this command to save those in
flash memory
Table 9-6 Extended AT Commands
9.2.6
Example Of The Extended AT Commands
Data
Description
AT+PLIP=192.168.1.200<CR>
▶ Setting Local IP Address
◀ <CR><LF>OK<CR><LF>
Command OK
AT+PGIP=192.168.1.254<CR>
▶ Setting Gateway IP Address
◀ <CR><LF>OK<CR><LF>
Command OK
AT+PSM=255.255.255.0<CR>
▶ Setting Subnet Mask
◀ <CR><LF>OK<CR><LF>
Command OK
AT+PNIP=192.168.1.254<CR>
▶ Setting DNS IP address
◀ <CR><LF>OK<CR><LF>
Command OK
AT+PLP=1470<CR>
▶ Setting Local Port
◀ <CR><LF>OK<CR><LF>
Command OK
AT+PTO=10<CR>
▶ Setting Timeout
◀ <CR><LF>OK<CR><LF>
Command OK
AT+PWP<CR>
▶
Write the parameters in the flash
memory
◀ <CR><LF>OK<CR><LF>
Command OK
◀ <CR><LF>NO CARRIER<CR><LF>
System rebooted
Table 9-7 Example of the Extended AT Command
9.3
On-line State and Command State
The ezTCP can operate in either Command State or On-line State.
Command State
The ezTCP is Command State right after power on. Incoming serial data is treated as AT
command
