Solidyne 542 APC, Руководство пользователя

Страница: 7 / 44

Section 1 Quick installation guide
POWER SOURCE AND TURN ON
Before plugging the unit to the AC line, check if the 110/240V VOLTAGE SELECTOR is in the correct
position. Use the supplied three-prong Interlok cable and ensure proper grounding.
The unit has an on/off switch on the rear panel.
CONTROL
Some basic functions can be set from the rack’s frontal panel. The operation is intuitive: Turn the jog
wheel to choose options or change values. Push the jog wheel to access options or to confirm a
value.
ETHERNET CONNECTION
All functions and settings of the 542APC are controlled from an internal WEB interface. Connect the
542 ACP's ETHERNET port to the LAN router, using a standard UTP cable. By default the unit works in
DHCP mode. The router will assign it an IP address, which is displayed on the OLED screen of the pro -
cessor.
WEB CONTROL
Using any network terminal, enter the IP address in a WEB browser. The browser will display the 542’s
internal WEB pages. The initial screen is a Status page. To change set and edit options, press the AD-
JUST MODE button located at the top right. Read this manual for details.
INPUTS
CONNECTION
Default active input is the balanced analogue with XLR connection. There is a second analog input
on RJ45 (StudioHub (c) compatible) and digital inputs AES3 and IP streaming (optional). To switch the
input proceed as follows.
SET UP
The analog inputs are set to operate at -18 dBfs with +4dBu nominal input level. When the mixing console peaks
are 0VU, signal peaks at the 542APC input should be between -22 and -9 dBfs. The input gain can be adjusted as
shown below.
INPUT SELECTION (from the frontal panel)
✔ Turn the jog wheel until see the INPUT screen.
✔
Press the navigation wheel to access to the "active input" configuration.
✔
Turn the wheel to select an input (number and name of the input are shown eg "2: ANALOG2").
✔ Press the wheel to confirm the selection.
✔ The current active input is signalized by an arrow (input levels screen).
CHANGE THE INPUT GAIN (from the frontal panel)
✔
Turn the wheel until see the "enter SETUP MENU" screen. Press the wheel to enter.
✔
Turn the wheel to select "IN" and press to enter SETUP of inputs.
✔
Press the wheel to select "INPUT SEL". Turn the wheel to select the desired input. Press to con-
firm.
✔
Select "GAIN" by turning the wheel and press to activate the gain change.
✔
Turn the wheel clockwise to increase the gain and counterclockwise to decrease it. Adjust the
gain so that the indicators show a peak value between -22 and -9 dBFS.
✔
Press the wheel to confirm the gain.
✔
Turn the wheel to select BACK and exit this menu.
✔
Turn the wheel to the last "BACK" icon to exit the SETUP menu. Changes are saved.
Audio Processing Core - SOLIDYNE 542 APC Page 7