Solidator 2.0, Руководство пользователя

Страница: 10 / 20

10
8. Put the red cover back on the Solidator. Notice that the cover has a magnet inside and that
this magnet needs to sit on inside-rear-right side of the red cover (printer viewed from the
front).
9. Please click on “Setup” and then select Calibrate → Motor, then press Start.
10. After this action, the motor will drive the printing plate to a position that aligns with the top
edge of the resin container. Remove the red cover and confirm that the top of the container
matches the lower edge of the print platform. Then put the red cover back again and press OK
to drive back up.
Resin Container Mounting and Airflow Check
You should wait until the resin container is acclimated to room temperature, when cold it is
possible for the container to deform.
I
nstall the resin container aligning with the full length clamps, tighten the clamps to ensure that
there is no vertical movement of the container.
Next you should check if the there is an air pocket of about 1mm everywhere between the glass
plate and the film of the container. This air pocket is crucial for the machine to work fine.
If you notice an irregular air pocket or if there is any moisture between the glass plate and
the film, using a clean cloth apply gentle pressure to the right side of the resin container
where the two air-exit holes are located. Gently tap the film on the left side of the resin
container until the film is no longer in contact with the glass. Contact customer support, if
problem persists.