Solid State Logic Matrix, Руководство пользователя

Страница: 62 / 156

R Re ec ca al ll liin ng g a a T TR R S Sn na ap ps sh ho ot t
Enabling Total Recall
In order to recall a snapshot of the desk’s settings, Total Recall must be Enabled. This is done by pressing the Display TR button
located at the top of the button list in the right of the tab, or by pressing
E En na ab bl le e
in the
T TR R
soft key menu (See Page 44). The
current status of the Total Recall is shown above the Display TR button, by either a green TR Disabled sign or a red TR
Enabled sign. In addition, the TR box in the bottom right-hand corner of the Remote window goes red to indicate when TR is
enabled (as shown below).
The console also provides indication that TR is enabled via the red and green AUTO lights at the bottom of the channel meters:
for any channel with no changes required, both lights will be on. For any channels which contain settings which do not correspond
with the selected snapshot, the green light will be on and the red light will flash.
Note that AUTO lights are also used for automation. See Pages 45 and 68 for details.
Once TR has been enabled, the Display TR button becomes the Disable TR button.
Important Note: When Total Recall is enabled, a number of LEDs on Matrix perform a different function from that
performed during normal operation. Additionally, due to the quantity of information which has to be detected, the processing
speed and sound quality of Matrix is significantly reduced when Total Recall is enabled. It is therefore important to disable
Total Recall when you have finished resetting a snapshot.
Selecting a TR Snapshot
There are three groups of settings within a TR Snapshot, listed on Page 56: Group 1 consists of switches and faders which can
be reset automatically. Group 2 consists of switches which require manual resetting. Group 3 consists of pots which require
manual resetting.
To select a TR snapshot, press the
Display TR button to enable Total Recall, highlight the snapshot which you want to recall
from the snapshot list in the centre of the Total Recall window, and press Select TR Snap . The console LEDs will now
indicate whether or not they correspond to the selected snapshot: LEDs are unlit to indicate where the snapshot and console
match, and lit to indicate where the they do not. If all you want to do is recall a specific selection of settings without setting the
snapshot to the whole desk or even a whole channel, this can now be done manually as described below.
Note that selecting a snapshot does not change any settings until a TR snapshot is ‘set’ (see next page). In the instance
of a selective reset, those settings which would normally be reset automatically by ‘setting’ a snapshot (Group 1) can also
be reset manually. In this case Group 1 controls function exactly as if they were part of Group 2. The exception to this is
the faders which have no TR indication.
Chapter 4 - Matrix Remote
54
Matrix Owner’s Manual