Solid State Logic C10 HD, Руководство по установке, Страница: 55 / 237

network Connections
C10 HD Installation Manual Section 3: Installation | Page 3-5
n
etWork
c
onnectionS
Assemble the two console networks as indicated by the appropriate diagram opposite.
• Standard cat-5e or cat-6 Ethernet cables are suitable for all network connections.
• Hubs should preferably be of an ‘auto-negotiating’ type or of at least 100BaseT capacity.
• The SSL and TCP/IP networks must be kept separated.
tcP/iP n
etWork
The remote PC, network hub and interconnecting cables are not supplied and will need to be sourced by the facility.
The PC may also be directly connected to the console’s TCP/IP Network port without the need for a hub. Note that in
this configuration the Ethernet cable used will need to be of the ‘crossover’ type.
The console does not support wireless networking.
SSL n
etWork
The SSL network is a closed proprietary network used to transfer data between the different items of SSL equipment –
including the optional MORSE router.
For single consoles, or for systems without a MORSE router or a GPIO box, the only connection that needs to be installed
is the 0.3m link between the DSP card and the SSL network port on the connector panel. (This lead will be located in the
console’s trim kit).
Redundant systems, multiple console installations or systems that include a MORSE router will almost certainly require an
external Ethernet switch to be supplied.
c
ontroL oF a
morSe
router
The routing matrix in a MORSE router can always be controlled by using the console’s touchscreen.
Routing, and optional scheduling, can also be controlled remotely using a PC by purchasing an appropriate license.
The file management PC can also be used to control a MORSE router providing it is equipped with two independent
network cards. This configuration will also allow additional suitably licensed PCs access the router.