Curtain Installation
Top Mounting Rail
1. Attach the top mounting
rail to the unit with short
screws (Fig.8)
Fig. 8
2. Slide the free end of the curtain into the side panel of the air
conditioner. Do this for each side. The flange for securing
the curtain into the window sill will be facing the room side
when installed ( Fig.9).
Weather Insulation Board
Fig.11
Curtain
Curtain
Fig. 9
Placing the Cabinet Inside the Window
1. Set the cabinet in the window so that is centered.
Place the unit so that front edge of the bottom rail is
against the back edge of the sill.
2. Bring the window down so that the front edge of the
top rail is in front of the window. Be sure the unit is
tilting slightly to the outside.
3. Fasten the curtains to the unit with short screws (Fig.10).
Window
Frame
1/4”
Top Rail
Bottom Rail
Fig. 10
Weather Insulation Board Installation
NOTE:
The Weather Insulation Board adds an extra layer of insulation
to keep air from passing through the sides of the window air conditioner.
1. Using a sharp blade or scissors, slowly cut the Weather
Insulation Board to a size that will fit inside of the side cur-
tain rails and completely cover the curtain.
2. Once properly sized, remove the backing to expose the ad-
hesive tape.
3. Place the Weather Insulation Board over the left curtain and
firmly press and hold for 5 seconds.
3. Fasten cabinet to window sill using three long screws. Pre-
drill holes if needed. Add the bottom rail seal over the
screws (Fig.12).
Bottom Rail Seal
4. Repeat above steps to install the Weather Insulation Board
on right curtain (Fig.11).
Fig. 12
Long Screw
INSTALLATION
ION
