1.
Freezing Conditions:
This is a cooling only air
conditioner. It is not designed for freezing outdoor
conditions. It must not be used in freezing out-
door conditions.
2.
Remote Control:
To ensure proper operation
when using the remote control, aim the remote
directly at the signal receiver on the air condi-
tioner.
The remote control has a signal range up to 20
feet.
Make sure nothing is blocking the remote control
signal from being received by the air conditioner.
Make sure the batteries are installed correctly
and still have power.
3.
Cooling Mode:
Use the Cool mode at High, Me-
dium, Low fan speed when cooling is needed.
Use the temperature
▲
or
▼
buttons to set the de-
sired temperature between 61°F-90°F.
Once the temperature is set, the compressor will
cycle on and off to keep the room temperature
at the set temperature level. The lower the set
thermostat temperature, the cooler the room will
be. The higher the set thermostat temperature,
the warmer the room will become.
For Normal Cooling - set the mode to Cool and
the Fan to High or Med with the temperature set
in the Middle.
For Maximum Cooling - set the mode to Cool
and the Fan to High with a lower set tempera-
ture.
For Quieter & Nighttime Cooling - set the mode
to Cool and the Fan to Low with the temperature
set in the middle.
4. Energy Saver Mode:
When the Energy Saver mode is
ON
, the fan will
cycle on and off with the compressor. This re-
sults more winder variations of room tempera-
ture and humidity. Normally, it is used when the
room is occupied. The fan may continue to run
for a short time after the compressor cycles off.
When the Energy Saver mode is
OFF
, the fan
runs all the time in fan or cool mode.
5.
Fan Only Mode:
Use Fan Only mode at High,
Medium, or Low fan speed to provide air circula-
tion and filtering without cooling. Since Fan Only
setting does not provide cool, a set temperature
cannot be entered. The room temperature will
appear in the display.
6.
Loss of Power Protection:
If power to the air
conditioner is lost or interrupted, the air condi-
tioner will automatically restart in the setting last
used prior to power loss. Timer will be cancelled
when power is lost or interrupted. You may need
to set a new timer if desired.
7.
Air Direction:
Use the lever on the front air
vents to adjust the airflow direction. You can di-
rect the airflow to left, right, up or down. The lever
is located on the lower left and right side of the
air vent.
8.
Auto Mode:
The air conditioner will automatically
choose Cool or Fan mode based on current room
temperature.
9.
Ventilation:
In order to maintain the best cooling
condition, pull the Fresh Air Lever to close the
vent. When fresh air is necessary, push the
Fresh Air Lever to open the vent allowing fresh
air being re-circulated in the room.
Fresh Air Lever
USE THE AIR CONDITIONER
