Electronic Control Panel & Remote Control
Note: This control panel display always shows the room
temperature in Fan Mode except when setting the tem-
perature and timer.
Normal Operating Sounds
You may hear a pinging noise caused by
water hitting the condenser on rainy days, or
when the humidity is high. This design feature
helps re- move moisture and improve
efficiency.
You may hear the thermostat click when
the compressor cycles on and off.
Water will collect in the base pan during rain
or days of high humidity. The water may
overflow and drip from the outside part of the
unit.
The fan may run even when the compressor
is not on.
1.
Power Button:
Turn the air conditioner on
and off.
2.
Digital Display:
Will display set temperature
when the unit is in Cool ,Dry, Auto, Sleep,
Energy Saver mode, and display current room
temperature when in Fan mode.
3.
Temperature Set
: Use these buttons on the
control panel or remote to increase or decrease
the Set Temperature.
4.
Timer Set:
Use these buttons on the
control panel and remote control to set the
timer. Each press of the
▲
or
▼
button will
increase or decrease the timer. For timer
instructions see #7.
5.
Fan Speed:
Use the fan speed button to
change the fan speed. Choose between
high, medium, and low.
6.
Mode Button:
Press the MODE button to
cycle through the various modes: Auto,
Sleep, Energy
7.
Auto-on Timer:
When the air conditioner is off,
it can be set to automatically turn on in 1-24
hours at the previous set mode and fan settings.
To set the Auto-on Timer, press the DELAY
TIMER button on the unit or remote control.
Timer can be set in 1 hour increment.
Auto-off Timer:
When the air conditioner is on, it
can be set to automatically turn off in 1-24 hours.
To set the Auto-off Timer, press the DELAY
TIMER button on the unit or remote control. Timer
can be set in 1 hour increment.
Once timer is set, TIMER ON/OFF indicator on
control panel will light up, the set temperature will
also shown on digital display.
To see the remaining time, press DELAY TIMER
button. To change the timer settings, use the
▲or▼ on control panel or remote control.
During preview of timer setting, press DELAY
TIMER button once to display set time, press the
button one more time to cancel the settings.
8.
Filter Reset:
After the fan rotates for 250 total
hours, the filter check light will turn on to
remind the user to clean the filter. Press the
FILTER RESET button to reset the reminder
once the filter is cleaned.
Signal Receiver:
Point the remote control
CONTROL PANEL LAYOUT
