This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord
and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flexi-
ble cord with no termination on the load side and a LCDI attachment plug on the line side.
The LCDI power cord and plug will remove the supply source via electrical disconnect (circuit trip) if the
nominal current leakage between the cord shield and either load conductor exceeds a predetermined value.
The cord will remain de
-
energized until the devise has been manually reset. This is intended to reduce the
risk of a fire in the power cord or combustible materials nearby. The cord shields are not grounded and they
must be considered a shock hazards if exposed. The cord shield must not be connected to ground or to any
exposed metal.
The test and reset buttons on the LCDI Plug are used to check if the plug is functioning properly. To test:
1. Plug power cord into wall outlet, the LED light will turn on.
2. Press TEST Button, circuit should trip, cutting power to the air conditioner. When this occurs,
the LED light will turn off.
3. Press RESET button to restore power to the unit. Once power is restored, the LED light will turn
on again.
If test button is pressed and unit can still be turned on, current leakage has been detected. Do not use the air
conditioner or attempt to reset the LCDI Plug. Contact Customer Service for troubleshooting recommenda-
tions.
Note: Your unit’s power cord may
differ from the one shown.
WARNING:
1.
DO NOT press the TEST button while the air conditioner is operating.
2.
The TEST and RESET buttons should not be used as
“
ON
”
and
“
OFF
”
switches.
3.
The cord and plug are not intended to offer protection to externally connected loads or supply circuits.
4.
The cord and plug are intended for indoor use only.
RESET
TEST
POWER CORD AND PLUG
Содержание PMC-12HP-201
Страница 7: ... WINDOW KIT ASSEMBLY ...