17
CONDENSATE EVAPORATION
Condensate Holding Tank
When the room temperature is low, and the indoor humidity is high, the air conditioner may not be able to
evaporate some of the moisture fast enough. When this happens, the water will accumulate in a condensate
tank inside the unit. Once the condensate tank is full, the unit will automatically shut off and the control
panel with display “
” (Full Tank). To empty the condensate tank, pull the drain plug at the bottom
back of the unit. You will need a small pan, approximately 1” high to catch the water coming out of the
condensate tank. Connect the supplied drainage tube to the back of the unit to aid in drainage into the pan.
Once the condensate tank is drained, the unit will begin working within a few minutes.
The unit, along with the fan will automatically shut off when the unit displays “
” (Full Tank).
To resume operation quickly, empty the water container according to the following steps:
1. Do not move the unit when the water container is full.
2. Place the drain pan under the drainage port at the back of the unit.
3. Remove the rubber plug from the drain hole. The condensate water will drain out automatically.
4. When the drain pan is full, install the rubber plug back onto the drainage hole to stop the water flow.
5. Empty the drain pan.
6. Repeat steps 2-5 until all the water is emptied.
Drain Plug
Drain Hole
NOTE:
Once the water container has
been emptied, firmly press the drain plug
back onto the drain hole. It is not advised
to use continuous drainage when the room
temperature is higher than 90˚F.
NOTE
: You may also use enclosed Optional Drain Tube to facilitate the
draining process, make sure to re-plug the Drain plug once the
condensation tank has been emptied.
