Sole Fitness Exercise Bike, Руководство пользователя, Страница: 24 / 28

23
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were installed
during assembly need to be tightened as much as possible. It may be necessary to use a
larger wrench than the one provided if you cannot tighten the bolts sufficiently. I cannot stress
this point enough; 90% of calls to the service department for noise issues can be traced to
loose hardware.
II. The crank arm nut needs to be retightened
III. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling
pads on the bottom of the rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust
the levelers.
MAINTENANCE MENU IN CONSOLE SOFTWARE
1. Press and hold the Start, Stop and Enter key at the same time, until the display shows
“Engineering Mode”. Press the Enter key.
2. You can now scroll through the menu using the Up and Down keys. Use the Stop key to return to
previous menu selection. The menu selections are:
A. Key Test
B. Display Test
C. FunctionsI.
I. Display Mode - Turn On to have the console power down automatically after 30 minutes of
inactivity
II. Pause Mode - Turned On to allow 5 minutes of Pause, turn Off to Pause indefinitely
III. ODO Reset - Resets the Odometer reading to zero
IV. Units - Choose from English(Imperial) or Metric display readings
V. Brake Test - For testing the Brake function
D. Security
E. Factory Settings - For Factory use only
F. Exit