Installation
Solé, S.A. C-243 b, km 2 · 08760 Martorell (Barcelona) ·Tel. +34 93 775 14 00 · www.solediesel.com · [email protected]
16
Marine diesel engines. Operator’s manual
Section 3 - Installation
3.1.
Angle of installation
Make sure the engine is installed on a level surface. Otherwise, the following angular
operation maximum is permitted:
Continuously
Temporaly
MINI-62
15º
20º (Max. 30 min.)
SM-103
15º
30º (Max. 30 min.)
If the engine operates in these conditions, check Section 5.4 Lubrication System.
3.2.
Engine Installation
Follow these steps to install the engine:
1.
FIX ENGINE. See Section 10 Overall Dimensions and Section 8 Tightening torques.
2.
ENGINE COUPLING. Couple the motor to the inverter, hydraulic pump, alternator or
power extraction mechanism correctly.
3.
CONNECT EXHAUST OUTLET. See Section 10 Overall Dimensions
1.
WET EXHAUST OUTLET
2.
DRY EXHAUST SEAWATER OUTLET
4.
CONNECT SIPHON BREAKER. (if installed) See Section 10 Overall Dimensions
3.
CONNECT SEAWATER INLET. See Section 10 Overall Dimensions
4.
CONNECT FUEL INLET. See Section 10 Overall Dimensions
5.
CONNECT LEAK COOLANT OUTLET. See Section 10 Overall Dimensions
6.
FILL WITH OIL. See 5.4 Lubrication System.
7.
FILL WITH COOLANT. See 5.6 Cooling System.
8.
CHECK EACH PIPE CONNECTION for oil or coolant leaks.
9.
PRIME THE FUEL SYSTEM. See 5.5 Fuel System
10.
CONNECT TO CONTROL PANEL. See
the Panel Control Operator’s Manual.
11.
CONNECT TO BATTERY. Follow label battery connection into the engine.
It is necessary to install a waterlock (supplied as accessory) in the exhaust system to avoid
water ingestion (See section 5.7)