SolarEdge Cellular Plug-In, Руководство по установке

Страница: 12 / 23

Chapter 4: Cellular Plug-in and Antenna
Installation
This chapter describes how to install a Cellular Plug-in and antenna in SolarEdge
devices that will communicate with the SolarEdge monitoring platform.
Clipping the Antenna to the Inverter
1. Power down the inverter:
a. Switch the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors
to discharge.
b. Turn the DC Safety Unit to OFF.
c. Cut off AC power to the inverter by turning off the circuit breakers on the
distribution panel.
2. Insert the clip from the bottom of the inverter between the bracket and the inverter
rear side.
3. Route the antenna cable upwards along the inner fins or the inverter side, by
threading the clip and RF cable from the bottom of the inverter between the bracket
and the inverter’s rear side.
Figure 8: Routing the antenna cable
4. Clip the antenna vertically to the heatsink fins or the inverter side.
NOTE
The antenna should point upward for maximum range.
To maximize the received signal strength, avoid sharp bends in the antenna
RF cable.
Chapter 4: Cellular Plug-in and Antenna Installation 11
Cellular Plug-in Installation Guide