Inline Energy Meter - External SolarEdge Energy Net Antenna Installation Guide
Introduction
The following guide provides installation instructions for the
External SolarEdge Energy Net Antenna of the Inline Energy Meter.
Kit Contents
External SolarEdge Energy Net Antenna with an attachment clip
and 1.8 meter cable
L-shaped Mounting Bracket
Plastic gland and internal nut
Three cable ties
This guide
Before you Begin
Scan for Inline Energy Meter
Quick Installation Guide
Scan for Inline Energy Meter
complete Installation Guide
WARNING!
HAZARD OF ELECTRIC SHOCK. Disconnect power to the electrical cabinet where the meter is installed. Do not proceed
beyond this warning note until local safety conditions are fully understood and met.
Locate a suitable location to install the Mounting Bracket of the External SolarEdge Energy Net Antenna. The bracket must enable
vertical installation of the antenna outside of the electrical cabinet. Make sure to maintain a radial clearance of at least 2.7" / 7 cm
from any metal surfaces.
For routing the antenna cable out of the cabinet, drill a hole in the enclosure (if permitted), and install the provided gland.
CAUTION!
When drilling holes to the cabinet, avoid damage to the internal parts by following the local safety regulations. Drilling
holes can be avoided by using existing holes and unused conduits.
Installing the Antenna
To install and connect the antenna:
1. Remove the Antenna Compartment Cover from the Inline Energy Meter.
2. Remove the Internal Antenna Board.
3. Remove the gland's external nut and rubber seal from the gland. Run the antenna cable through the gland's external nut and
rubber seal, into the Cabinet and reconnect the gland's external nut.
4. Fasten the gland to the cabinet using the internal nut using a torque of 1.5-2.5 Nm / 13.3-22.1 inch-pound.
MAN-01-00839-1.2 Inline Energy Meter - External SolarEdge Energy Net Antenna Installation Guide
Inline Energy Meter - External SolarEdge Energy Net Antenna Installation Guide
1
