Page
1
of
2
Solar Goes Green RGB Solar Flood Light
SGG-RGB-54-2R
Read and follow all instructions before operating your solar light, save this manual for future reference.
PARTS
--- 1 x 13.5V,20W mono crystalline solar panel
--- 1 x LED lamp housing including 11.1V,8Ah li-ion battery
--- 1 x wireless RF remote control
--- 2 x Wall/Flat mount kit for solar panel
--- 1 x Wall mount screws and dry-anchors
INSTALLATION
INSTALLATION OF SOLAR PANEL
Choose a place to situate the solar panel where there is abundant sunshine during the day. This unit requires at least eight hours of direct
un-obstructed sunlight to charge the battery.
Any cover or awning that shades the panel will affect its performance to charge the battery resulting in a shorter run time of the light during
the night.
The selected location should not be near a night time light source like a porch or street light. If the panel receives light on it at any time it will
not allow the automatic day/night sensor to turn the light on.
INSTALLATION OF LIGHT
Mount the led lamp at the desired place where you need light at night by using the metal dry-anchors and screws. Note: Rubber black covers
are provided to place over exposed stem and nut. The light head is adjustable vertically but not horizontally.
Plug the solar panel cable into the cable from the led lamp and secure with coupling provided.
Turn on the switch which is located at the bottom of lamp, the light will shine after 5 seconds. Then turn off.
To test operation of unit, completely shield the face of solar panel by laying it face down on a flat surface or cover the panel with thick black cloth. The
Lamp will turn ON after 5 seconds and remain on until solar panel is face to sun light again. This is normal test for day/night sensor.
THE SWITCH
When power switch is switched to the, position, light will automatically turn on when it’s dark enough. The light will shine at full
capacity for approximately 8-10 hours on a full charge. When solar panel senses no charge coming from the panel (which indicates it is dark),
the light will turn on, if there is charge (which indicates there is light on the panel), the light will not illuminate.
There are three settings for the switch:
o
– Turns the power on, will allow the solar panel to charge the battery and run the light by remote
control.
o
O
– Turns the unit completely off, there is no charging or light on this setting
o
– Operation to charge the battery only.
RF REMOTE CONTROL
The solar flood light comes with RF touch controller, which can operate the light from 75 feet away.
Note: 3 each of AAA alkaline batteries included. Not charged by panel. Must be replaced every 6 months or as needed.
DIRECTION OF REMOTE CONTROLLER USE
1.
--- OFF
2.
---Turn on or (change each touch ring and dynamic mode)
3.
----Patterns add 1 by each pressing; (refer to the following form below)
4.
----Patterns subtract 1 by each pressing; (refer to the following form below)
5.
---The speed or brightness change add 1 by each pressing, total of 128 steps
6.
---The speed or brightness change subtract 1 by each pressing
7.
---Touch color ring, brightness is adjustable and pattern is fixed by ring color selected by touch
