Softing FG-200 HSE/FF, Руководство пользователя

Страница: 10 / 82

FG-200 HSE/FF Modbus - User Manual
10
Version EN-112021-1.30.3
2.4 Safety precautions
Use in hazardous areas
The FG-200 is an electrical equipment with degree of protection Ex ec, approved for use in Zone 2
hazardous areas or in the safe area. The four FF-H1 interfaces are designed according to the protection
method Ex ic. Only certified circuits with an according protection method shall be connected to these FF-
H1 interfaces.
Special hints for safe use
§
Before setting the FG-200 into operation, the corresponding field has to be marked (e.g. if the
device is used in an IC environment, mark the upper field on the type label).
§
Use an appropriate permanent pen for signing, e.g. an etching pen.
§
More than one marking is not allowed. If you need a second marking, you must replace the
existing equipment with a new one.
§
An equipment which has been operated under non-intrinsically safe conditions is no longer
permitted to be used under intrinsically safe conditions.
The FG-200 HSE/FF Modbus is only approved for intended and appropriate use. In case of noncompliance,
the warranty and manufacturer’s liability do no longer apply!
CAUTION
During operation, the device's surface will be heated up. Avoid direct contact. When servicing,
turn off the power supply and wait until surface has cooled down.
Note
Do not open the housing of the FG-200. It does not contain any parts that need to be
maintained or repaired. In the event of a fault or defect, remove the device and return it to
the vendor. Opening the device will void the warranty!