Softing echolink one2PROFINET, Инструкция по эксплуатации

Страница: 44 / 60

15.1.15 echolink one2PROFINET V. 1.0 44
Softing Industrial Automation GmbH Hardware ports, switches and LEDs
This LED is connected directly to the supply voltage of the PROFINET-side.
9.3.2 LED "Link / Act. P1"
This LED is directly controlled by the PROFINET-processor and shines when the gateway at Port
1 (X3 P1) is in an operable network (link-pulses are received) and it flickers when network data
traffic takes place.
9.3.3 LED "Link / Act. P2"
This LED is directly controlled by the PROFINET-processor and shines when the gateway at Port
2 (X3 P2) is in an operable network (link-pulses are received) and it flickers when network data
traffic takes place.
9.3.4 LED "(PROFINET) State"
Off Waiting for Script command "Bus Start"
Lights green Connection with IO-controller available, data exchange active
Flashes green PROFINET initialized. Waiting for connection with IO-controller
Flashes red PROFINET flash indication
9.3.5 LED "Power"
This LED is connected directly to the supply voltage of the serial interface (RS232/422/485).
9.3.6 LED "State"
Lights green Data exchange activ via serial interface
Flashes green RS-interface OK, but no constant data exchange
Flashes green/red No data exchange since switching on
Lights red General Gateway error (see LEDs Error No.)
Flashes red echolink one is in the configuration / test mode
9.3.7 LEDs 1 / 2 / 4 / 8 (Error No. / Select ID)
If these 4 LEDs flash and LED “State“ simultaneously lights red, the error number is displayed in
binary notation (conversion table, see Annex) in accordance with the table in chapter "Error
handling".