Sodi RS3 KZ DD2, Руководство пользователя и по обслуживанию

Страница: 11 / 50

MAN_Sigma_EN_02
USER AND MAINTENANCE MANUAL
11
EN
Seat Position
● Position the seat following dimension B.
● Drill a 8.5 mm diameter hole in the seat.
● Tighten up screws and washers on assembly points (1).
3.7 - Assembly of the seat stiffeners
● See Standard adjustments, p. <EX> for the
assembly dimensions corresponding to the
standard setting recommended for your frame.
Lower end
1
2
Legend
1
Seat stiffener
2 Screw
● Put the seat stiffener lower end (1) in place.
● Pre-tighten the assembly with the screw (2).
●
For screws and nuts references, refer to the
spare parts catalogue.
Upper end
1
2
1
Legend
1
Seat stiffener
2 Screw + conical nut
● Place the upper end of the stiffener.
● Make sure there is no contact with the exhaust system
and with any part of the engine.
If necessary, slightly bend the stiffener.
● Drill a 8.5 mm diameter hole in the seat.
● Place one screw + conical washer (2).
● Tighten both upper and lower end.
● Apply the same procedure to mount the stiffener on the
left side of the seat.
●
For screws and nuts references, refer to the
spare parts catalogue.
● For other types of stiffeners, refer to the spare
parts catalogue and the web site ITAKA.
● It is possible to install several seat stiffeners
(left and right).