SnowWolf AlphaBlower 33-100-H, Руководство по эксплуатации и техническому обслуживанию

Страница: 22 / 98

20
AlphaBlower Operation and Maintenance Manual
Operation
Wireless Controls
33-100-H
NOTE: Wireless controls operate the 33-100-H
only.
Operation
• To turn on the transmitter, press and hold the
POWER button for at least 2 seconds and
release.
• To turn off the transmitter, press and hold the
POWER button until the LEDs turn off.
• The transmitter Is designed with a power
saving feature which turn the transmitter off
after 15 minutes if no buttons are pressed.
• There are red and green LEDs both on the
keypad of the transmitter and Inside the
receiver case. The green LED will blink rapidly
when the transmitter and receiver are
communicating. It will blink slowly if there Is no
communication (I.e. - no power to the receiver).
• The red LED on the receiver will blink if there Is
a shorted or open output. Refer to the ERROR
CODE CHART tables and count the number of
blinks to determine the output with the fault
(NOTE: the receivers with CAN do not have
output error codes).
• The transmitter's red LED blinks 1 time per
second if the battery Is low and needs to be
charged.
• The red LED will stay on while charging and
when the charge is completed the green LED
will stay on.
• It will take longer to charge if the transmitter is
on during charging.
Synchronizing Transmitter and
Receiver
Each transmitter and receiver pair is synchronized
together at the factory. If a new transmitter is
needed, synchronizing is required. Use the
following procedure:
1. Make sure both the transmitter and receiver
are off.
2. Press and hold the POWER button on the
transmitter for more than 10 seconds. The red
and green LED will start to blink.
3. Apply power to the receiver.
4. Wait for a few seconds until only the green LED
begins to blink on the transmitter.
5. Synchronizing complete.
Programming
The user can determine output functionality
(momentary or maintained action) and program
the system to respond as desired. This is
determined by the following procedure:
1. Turn the receiver off. Turn the transmitter on
(press and hold POWER until both LEDs turn
on, then release).
2. Press and hold 1,4, and 8 and release. Red
LED should be blinking on the transmitter.
3. Turn the receiver on, make sure the green LED
is blinking before proceeding to the next step.
Be sure all outputs are connected to a load and
that there are no error codes present (NOTE:
outputs may cycle on and off while
programming).
4. Are any outputs to be latched (push on/push
off)? If yes continue. If no, skip to step 9 for
outputs to be momentary.
5. Press button 1-8 corresponding to output 1-8
that is to be latched, until green LED goes on,
then off.