SNOWJOE SJ617E, Руководство оператора

Страница: 13 / 20

13
Maintenance
Lifetime Lubrication (Motor and Auger)
Lubrication is not necessary and may damage the unit. The
snow thrower is lubricated for lifetime use at the factory before
shipment.
General Maintenance Tips
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe working
condition.
3. After each snow removal session, run the snow thrower
for a few minutes to prevent the collector/impeller from
freezing. Shut off the motor, wait for all revolving parts to
stop completely, and wipe residual ice and snow off the
unit. Rotate the chute crank several times to remove any
excess snow.
4. Only use a cloth soaked with hot water and a soft brush to
clean the snow thrower; never wet or spray water on the
machine!
5. Do not use detergent or solvents as these could cause
irreparable damage to the snow thrower. Chemicals can
destroy the plastic parts.
6. To protect the snow thrower from corrosion when storing
for long periods, lightly oil the metal parts.
7. Store the appliance in a dry area out of reach of children.
8. For the user's safety, worn or damaged parts must be
replaced. Replace with original replacement parts only.
Parts from another snow thrower may not fit properly,
causing an unsafe situation.
Replacing the Plastic Auger
NOTE: When replacing worn plastic plates, pay close attention
to any different types of bolts and nuts and where they are
positioned. This will ensure that the new plastic plates are
installed properly and securely.
1. Open the two side covers by removing the 5 screws on
each side (Figs. 30 – 31).
2. Remove the belt from the drive wheel on the left side
(Fig. 32).
m
WARNING
m
Make sure to turn off the switch and disconnect the
extension cord before performing any maintenance
task on your snow thrower.
Fig. 30
Screws Screws
Fig. 31
Fig. 32
Belt