15
Replacing the Scraper Bar
1. The scraper bar is located at the base of the snow thrower
beneath the rotor housing (Fig. 30
).
2. Remove the screws that secure the scraper to the snow
thrower (Fig. 31
).
3. Install the new scraper bar and fasten it securely to the
snow thrower with the screws.
Replacing the Belt
NOTE:
Under normal operating conditions, it should not be
necessary to replace the auger belt. However, should the
auger jam or malfunction, the belt could be damaged. To
replace the belt, follow the instructions.
NOTE: Determine the left and right hand side of the snow
thrower by standing behind the unit in the normal operating
position.
1.
Open the left side plate by removing
the 4 screws
(Fig. 3
2).
2. Use your right hand to turn the rib side of the belt
up and pull upwards while turning the auger pulley
counterclockwise with your left hand. The belt can be
easily removed from the pulley (Fig. 33).
3.
Put the belt on the drive pulley first and then place the
belt at the lower end of the auger pulley (Fig. 34).
4. Use your right hand to press the belt with the ribbed side
down. While holding the belt down with your right hand,
use your left hand to turn the auger forward so that the
auger pulley rotates in a clockwise direction. The belt will
be gradually pushed down onto the pulley. When the belt
is seated on the pulley, adjust it so that the ribs of the belt
match the grooves on the pulley. (Fig. 35
).
Fig. 30
Scraper bar
Fig. 31 The screws that secure the scraper bar
Fig. 32
Screw
Side cover
Fig. 33
Belt
Fig. 34
Auger pulley
Drive
pulley
Fig. 35
