14
2.
Raise or lower the chute deflector to the desired height of
the snow stream by hold the discharge chute handle and
press the chute deflector trigger
(Fig.
19
).
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
®
24V-X2-20SB cordless snow blower, please visit
snowjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Make sure the unit is off and remove the
batteries before performing any maintenance tasks on your
snow blower.
Lifetime Lubrication (Motor + Auger)
Lubrication is not necessary and may damage the unit.
The snow blower is lubricated for lifetime use at the factory
before shipment.
General Maintenance Tips
m
WARNING!
Always switch the product off, remove
the batteries, and let the product cool completely before
inspecting, cleaning, or performing any other maintenance
task.
m
WARNING!
Only perform the repairs and maintenance
work described in this manual. Any other work must be
performed by a qualified technician.
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check
bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe working
condition.
3.
After each snow removal session, run the snow
blower
for a few minutes to prevent the collector/impeller from
freezing. Shut off the motor, wait for all revolving parts to
stop
completely, and wipe residual ice and snow off the
unit.
Rotate the chute deflector by the chute control crank
several times to remove any excess snow.
Replacing the Scraper Bar
IMPORTANT:
Only use original replacement parts specified for
this snow blower.
You can purchase a replacement scraper bar (Model 24V-X2-
20SB-SCRPR) and other genuine replacement parts by visiting
us online at snowjoe.com or calling our toll-free customer
service helpline at 1-866-SNOWJOE (1-866-766-9563).
The use of parts that do not meet the original equipment
specifications may lead to improper performance of the snow
blower, may compromise operator safety and will void the
manufacturer's warranty.
1.
Turn off the snow blower, remove the batteries and wait
until the snow blower comes to complete standstill.
2. Open the two side panels by removing the 8 screws on
each side (Fig. 20).
Fig. 18
Chute crank
Discharge chute
Discharge
chute trigger
Fig. 19
Screws
Fig. 20
Side panel
Side panel
Screws
