Lit. No. 74912, Rev. 00
14
May 1, 2020
OPERATIONAL TEST AND FINAL ADJUSTMENTS
CENTER CUTTING EDGES
The center cutting edge spacer plate is located on the
T-frame below the pivot pin hinges.
1. With the blade wings in the "Vee" position, the
center cutting edges should touch the center
cutting edge spacer plate. If they do not touch the
spacer plate, adjust the center cutting edges as
follows.
2. Loosen the four 5/8" x 2" center cutting edge
carriage bolts, but do not remove them.
3. Slide the center cutting edges inward until they
contact the spacer plate.
4. Re-tighten the center cutting edge carriage bolts
according to the torque chart.
LUBRICATING THE PIVOT PIN HINGE
Using a rubber-tipped seal-off coupler tip, apply a
good quality multipurpose grease at the five grease
points along the center pivot pin hinge.
5/8" x 2"
Carriage Bolts
Spacer Plate
Center Cutting Edge
Grease
Points
