Snorkel S2770RT, Руководство оператора

Страница: 40 / 56

Chapter 8 – Operation
36 S2770RT IS – 0102094
6. At the rear of the platform, close and latch the entry
gate and remove the hardware snapper pins from
the corners of the rear guardrail. Refer to Figure 8.9.
Figure 8.9 – Lower Controls
7. Fold the rear guardrail inward so it rests on the plat-
form being careful to keep the entry gate latched.
8. Lift up on the right guardrail and fold it inward so it
rests on the platform. Repeat with the left guardrail.
y
If the guardrail will not fold down, loosen the
hardware at the bottom of the side guardrail.
Use the following procedure to reassemble the guard-
rails before operating the aerial platform from the upper
controls:
1. Fully raise the right guardrail to the upright position
and push downward on the guardrail making sure it
securely sets into the platform. Repeat with the left
guardrail.
2. Fully raise the rear guardrail to the upright position,
being careful to keep the entry gate latched. Connect
the rear guardrail to the left and right guardrail by
reinstalling the hardware (nuts, bolts, spacer, wash-
ers etc.) to the corners of the guardrails and tighten
securely.
3. Fully raise the front guardrail to the upright position.
Connect the rear guardrail to the left and right guard-
rail by reinstalling the snapper pins to the corners of
the guardrails.
Platform Extension Deck
The platform extension deck can be securely locked into
eleven different positions.
Use the following procedure to extend the platform.
1. Enter the platform and secure the door.
Rear Guardrail
Hardware
Side Guardrail Hardware
A
Caution
The extension deck is free to move when the exten -
sion handle locks are disengaged. Personal injury
may result from accidentally extending or retracting
the deck. Make certain both extension handle locks
are fully engaged when the deck is extended in the
working position and when it is stowed. Do not at-
tempt to extend or retract the platform unless the
aerial platform is on a level surface.
2. While facing the front of the platform, release the
platform extension handle locks. Grasp the handles,
raise them and push the extension deck forward to
the desired position. Fully lower the handles and
ensure the lock on each handle is engaged in the
slot on the platform guardrail (refer to Figure 8.10).
Figure 8.10 – Platform Extension Handles
3. Lock the extension handles in the downward position.
Use the following procedure to retract the platform.
1. Enter the platform and secure the door.
A
Caution
The extension deck is free to move when the exten -
sion handle locks are disengaged. Personal injury
may result from accidentally extending or retracting
the deck. Make certain both extension handle locks
are fully engaged when the deck is extended in the
working position and when it is stowed. Do not at-
tempt to extend or retract the platform unless the
aerial platform is on a level surface.
2. While facing the front of the platform, release the
platform extension handle locks. Grasp the handles,
raise them and pull the extension deck backward to
retract the deck. Fully lower the handles at the fully
retracted, stowed position. Ensure the lock on each
handle is engaged in the slot on the platform guardrail
(refer to Figure 8.10).
3. Lock the extension handles in the downward position.
Lock
Extension Handle
Slot on Guardrail