Snorkel S2646, Руководство пользователя

Страница: 177 / 236

S2646/S3246 Maintenance – 7
Item
Electrical System
Batteries
Cables and wiring harness
Battery charger
Hydraulic System
Hydraulic fluid condition
Fluid reservoir
Return filter
Hoses, tubes, and fitting
Fluid level
Filler cap
Free-wheeling valve
Motor and pump assembly
Structures
Weldments
Slide pads
Fasteners
Tie Rod Ends
Wheels and Tires
Steering Cylinder – Fasteners
and Linkage
Scissor Structure
Pivot pins, snap rings, bolts
and nuts
Lift cylinder and valves
Emergency lowering system
Hoses, tubes, and fitting
Cables and wiring harness
Safety prop
Parking Brakes
Frequent Inspection and Maintenance – Every 90 Days or 150 Hours
Procedure
Clean terminals, check electrolyte
levels and cable connections
Check for wear and damage
Check for proper operation
Visually inspect a sample taken from
the center of the reservoir. Do a lab test
if necessary. Flush the system and
replace the fluid as necessary.
Check for leaks
Replace after the first 50 hours, every
90 days or 150 hours thereafter
Inspect filter for foreign matter that
could indicate component wear
Check for leaks, blistering, cracks, etc.
Fill with proper fluid, between Full and
Add marks
Check for wear and securely fasten
Fully close
Check for damage and leaks
Check for proper operation
Check for damage and cracked welds
Check for wear and proper operation
Verify that all fasteners are in place
and are tight
Lubricate with spray lubricant
Check for wear and damage
Retorque lug bolts/nuts to 90 to 100 ft lb
Check for cylinder damage and leaks
Check for proper operation
Lubricate with spray lubricant
Check for damage and cracked welds
Check for wear and damage, or
missing components
Check for wear/damage/leakage and
proper operation
Check cables for wear and damage
Verify that all fasteners are in place
and are tight
Check for leaks, blistering, cracks, etc.
Check for wear and damage
Check for damage and deformation
Check for leaks and proper operation
Information
Add distilled water if
necessary
Ensure batteries are fully
charged
Above 10°F (-13°C)
Mobil DTE-13M, ISO VG32
Below 10°F (-13°C)
Mobil DTE-11M, ISO VG15
See above
Do not lubricate
Petroleum based such as WD-40
Petroleum based such as WD-40
Ok