Snorkel S1930E, Руководство оператора

Страница: 45 / 58

Chapter 9 – Operation
S1930E/S1932E/S2632E – 1360460 41
Figure 9.6 – Platform Pin
4. Remove the pins from the platform extension deck
vertical rails and fold the guardrails down to rest on
the floor of the platform.
Note
It may be necessary to extend the platform approximately
6 ″ (15 cm) to remove the pins at the front of the platform.
If so, make certain to relock the extension deck in the
stowed position.
5. Remove the pins (refer to Figure 9.6) that connect
the rear panel to the guardrails on the right side of
the platform. Fasten the rear panel to the mid rail on
the left side of the platform.
6. Remove the pins from the platform deck vertical rails
and fold the guardrails down to rest on the floor of
the platform.
7. Reverse this procedure to reposition the rails.
Swing-Out Trays
Batteries and hydraulic components are enclosed in
swing-out trays (refer to Figure 9.7) on each side of the
chassis.
Figure 9.7 – Swing-Out Tray
The battery tray on the left side of the chassis con-
tains the battery disconnect, batteries and the battery
charger.

The hydraulic tray on the right side of the chassis
contains the lower controls, the hydraulic reservoir,
and the hydraulic fluid filter.
Danger
The aerial platform can tip over if it becomes unstable.
Death or serious injury can result from a tip-over ac -
cident. Do not open the trays when the platform is
raised more than eight feet.
To open the swing-out tray, push down on the latch and
swing the tray open.
Electrical Power Outlet
The electrical power outlet has two, 3-prong, 125 volt AC
electrical connectors (refer to Figure 9.8). Their combined
output is limited by a 15 amp circuit breaker.
Figure 9.8 – Electrical Power Outlet
Power is supplied to the outlet by connecting an external
power source to the power-input connector at the rear of
the chassis (refer to Figure 9.9).
Figure 9.9 – Rear of Chassis
To use the outlet, plug a source of power into the power-
input connector. Unplug the source of power before
moving the aerial platform.

Pin
Latch
Tray
Power-Input Connector