Snorkel S1930E, Руководство оператора

Страница: 34 / 58

Chapter 8 – Prestart Inspection
30 S1930E/S1932E/S2632E – 1360460
Use the following procedure to operate and test the ma-
chine from the upper controls:
1. Make sure the battery disconnect is turned on.
2. At the lower controls, pull the emergency stop button
outward.
3. Place the control selector switch upward in the upper
control position.
4. At the upper controls (refer to Figure 8.19), pull the
emergency stop button outward.
Figure 8.19 – Upper Controls
Warning
The potential for an accident increases when operat-
ing an aerial platform that is damaged or malfunction-
ing. Death or serious injury could result from such
accidents. Do not operate the aerial platform if it is
damaged or malfunctioning.
5. Test the interlock switch by moving the joystick with-
out engaging the interlock switch.
If movement occurs the interlock is not functioning
properly. Do not operate the machine until the prob-
lem is corrected.
6. Place the drive/lift selector switch in the drive position
and test the operation of the joystick in both direc-
tions. The lift functions should not operate with the
selector in the drive position.
Squeeze and hold the interlock switch against the
joystick. Test the steer switch in both directions using
the steering switch.
To steer to the right, hold down the right side of
the steer switch.
To steer to the left, hold down the left side of the
steer switch.


4. Inspect the weldments for deformation and damage.
Try to move the rails back and forth to make sure the
platform extension deck is locked in position.
5. Visually check the platform welds for cracks.
6. While facing the front of the platform, depress the foot
lever and grasp the top rail of the extension deck. Pull
backward to retract the deck until the pin engages
the rear stop (refer to Figure 8.17).
7. Make sure the platform extension deck is locked in
position.
Fold Down Rails
Inspect the pins that hold the rails in position (refer to
Figure 8.18) to make sure they are in place and are not
deformed. There is one pin on each vertical side rail, the
entry gate, the front panel and one that fastens the upper
controls to the platform rails.
Figure 8.18 – Fold Down Rails Pin
Operating Controls
Warning
The potential for an accident increases from improp-
erly driving or steering the aerial platform. Death
or serious injury could result from such accidents.
Make sure the upper control panel is at the front of
the platform, hooked on the guardrail, and hanging
inside the platform.
Avoid driving the platform with the upper controls facing
the rear or side of the machine. In this position the ma-
chine is difficult to control because the drive and steer
control movements and their resulting machine move-
ments will not correspond.
Only operate from the upper controls when it is at the front
of the platform, hooked on the guardrail, and hanging
inside the platform facing the front of the platform.
Pin
Joystick
Emergency
Stop Button
Steer Switch
Interlock Switch
Horn
Drive Range Switch
Drive/Lift
Selector Switch