Sno-Tek 920402-Sno-Tek 24E, Руководство оператора

Страница: 29 / 38

GB - 29
IMPORTANT: NEVER store the engine with
fuel in the fuel tank inside of a building with
potential sources of ignition.
Add Fuel Stabilizer
1. Turn the fuel valve off while engine is
running and allow the engine to run until
it stops. Turn engine OFF when it begins
surging to avoid engine damage.
2. Add fuel stabilizer, following the
manufacturer’s instructions.
3. Turn fuel valve on after adding fuel
stabilizer.
4. Re-start engine.
5. Run the engine outdoors for 5 minutes to
be sure that treated gasoline has
replaced the untreated gasoline in the
carburetor.
6. Slow the engine to an idle speed.
7. Repeat step 1 above.
SERVICE PARTS
Order the following parts through your
dealer:
Part No. Description
00036800 Ariens Hi-Temp Grease
(3, 3 oz. cartridges)
21547400 Spark Plug
07200513 Impeller Belt
07200603 Traction Belt
53200500 Shear Bolts
00170800 Friction Disc
00592900 Gas Stabilizer (4 oz.)
ACCESSORIES
See your authorized Ariens dealer to add the
additional accessories available to your
Sno-Tek model.
Part No. Description
72000200 Slicer Bar
72406500 Front Weight Kit
72600300 Composite Skid Shoe Kit
73203600 Snow Thrower Cover
72408000 Snow Cab Kit
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
Engine will
not
crank/start. 1. Fuel tank is empty.
2. Fuel shut-off valve
closed.
3. Build up of dirt and
residue around
governor/carburetor.
4. Key switch not in run
position.
5. Engine start switch turned
off.
1. Fill fuel tank. DO NOT
OVERFILL! (see Filling Fuel
Tank on page 15).
2. Open fuel shut-off valve.
3. Clean area around
governor/carburetor.
4. Put Key switch into run
position.
5. Turn switch on. See Starting
and Shut Off on page 16.