Sno-Tek 920402-Sno-Tek 24E, Руководство оператора

Страница: 18 / 38

GB - 18
Ariens dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
SERVICE POSITION
(Figure 12)
Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service. Ensure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
*
Refer to Engine Manual for detailed
instructions.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches
must
disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
MAINTENANCE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Before tipping unit up
onto housing, remove fuel so no spills
will occur. Ensure unit is secure and
will not tip over during maintenance.
Figure 12
Service Position
MAINTENANCE SCHEDULE
Service
Performed Each
Use Every
5 hrs. Every
25 hrs. Yearly
Check Dual
Handle
Interlock •
Check
Fasteners •
Check Clutch
Operation •
Clean Engine •
Check Engine
Oil *
Change
Engine Oil*
Check Tire
Pressure
•
Check Auger
Gearcase • •
General
Lubrication • •