Sno-Tek 920402-Sno-Tek 24E, Руководство оператора

Страница: 10 / 38

GB - 10
Install Remote Deflector Cable
(920402, 403)
(Figure 7 and 8)
1. Slide cable through clip on top of
discharge chute pedestal (Figure 7).
2. Bend clip closed around cable.
3. Using the wire hook attached to the
deflector cable, hook cable to discharge
chute crank.
4. Pull rubber seal cap away from snap
fitting.
5. Install snap fitting into cable bracket’s
mounting hole located under the dash.
6. Position rubber seal cap over the top of
snap fitting.
7. Move deflector control lever to rear most
position.
8. Attach cable eye to pin on bottom of
deflector control lever.
NOTE: Hold down chute deflector cap, if
needed, for more cable slack.
9. Secure cable eye to control lever with
washer and hairpin.
10. Test controls to be sure deflector works
properly.
If deflector does not follow full range of travel
See
Remote Discharge Deflector Control
Adjustment (920402, 403) on page 22.
1
3
2
4
5
Figure 7
1. Remote Deflector Cable
2. Remote Deflector Control
3. Cable Clip
4. Wire Cable Hook
5. Cable Mounting Bracket
1. Mounting Hole
2. Snap Fitting
3. Rubber Seal
Cap
4. Hairpin
5. Washer
6. Cable Eye
Figure 8
2
1
3
4
6
5