BTP-P36 User’s Manual
- 34 -
2) Put the sphere parts into the groove. Then put the right belt clip cradle
into the groove, refer to
①
in figure above. Finally, put the belt clip
③
into the groove.
3) Wrest the pan head self-tapping screwinto bottom cover using
screwdriver. The pan head self-tapping screw is ST2.9×8-F-Hsupplied
with the belt clip package.
Remarks:
When fastening screw, rotate the belt clip to one side so as not to block
the screw mounting hole.
The mounting screws are supplied with the belt clip package.
6.5 Printer power on and self-test
6.5.1 Power on the printer
1) Make sure the printer battery is fully charged and install in place;
2) Press the [power] button for more than two seconds. The printer will turn
on and initialize.
6.5.2 Print the self-test page
1) Make sure the printer battery is fully charged and installed in place, and
install the paper roll;
2) Press the "configuration" button while the printer is idle. The printer
enters the configuration menu.
3) Press "UP" or "DOWN" to select "2. SELFEST" or "2.SELFTEST" and
press CONFIRM to confirm;
