Snapper GROUNDS CRUISER GC9520KW, Инструкции по безопасности, установка и руководство оператора

Страница: 22 / 33

22
SECTION 3 – MAINTENANCE
3.5 SERVICE – EVERY 200 OPERATING HOURS
(OR YEARLY)
3.5.1. Perform all maintenance required after 50
hours of operation. Refer to Section “Service – Every
50 Operating Hours”.
3.5.2. Change Transmission Fluid
1. Remove drain plug located on left bottom side of
transmission case. Drain fluid into 6 quart
minimum capacity pan. See Figure 3.6.
FIGURE 3.6
2. Allow fluid to drain completely. Reinstall drain
plug and tighten securely.
3. Fill transmission with 5.6 qt of MOBILFLUID 424
or equivalent.
4. Check fluid level and top off as needed. Do Not
over fill.
WARNING
Gasoline is an extremely flammable liquid and its
vapors are highly explosive. Handle only outdoors
in an open, well ventilated area where vapor can
dissipate safely and away from all sources of
ignition.
3.5.3. Replace Fuel Filter
1. Engine must be cool before proceeding.
2. Remove clamps from filter.
3. Remove hose from fittings on filter. Be prepared
to collect small amount of fuel as it drains from
the hose.
4. Dispose of old filter. Do Not attempt to clean and
re-use.
5. Slide hose over fittings on new filter.
6. Reposition clamps over fittings on filter.
7. Clean up any spilled fuel.
8. Start engine and check for leaks.
3.6 STORAGE (OUT OF SEASON)
3.6.1. Perform all maintenance as specified in the
“Maintenance Schedule” in this manual and in the
Engine Owners Manual.
1. Drain Fuel Tank. Drain fuel into approved
container and store away from source of
ignition.
2. Run Engine to empty carburetor bowl.
3. Remove battery and add water as needed to
fill cells to proper level.
4. Charge Battery and store in cool dry place.
5. Store the machine in a cool, dry, protected
place.
TRANSMISSION
FLUID DRAIN
PLUG