LAN IP Setup Quick Start Guide
© 201
8
WattBox®
Rev. 180531-1550
Page 1
Introduction
Follow this document to configure WattBox IP device web interface access using the WattBox-IP Utility. This may be
completed in addition to OvrC setup for access to all of the settings in the WattBox IP interface.
Before You Begin–Firmware Updates
Always check the firmware version of a new WattBox IP before configuring settings in the web interface or OvrC.
•
300, 500, and 700 series models: firmware can be updated using OvrC. Instructions and the firmware files are
available directly from OvrC.
•
For 200, 400, and 600 series models: firmware must be updated using the WattBox IP utility software or the web
interface. Download the newest firmware .zip file from the product support tab at
SnapAV.com
before continuing.
Setup Instructions
1. Install the WattBox
Follow the installation manual to complete hardware setup, then follow the directions found on the OvrC QSG to claim
the device. Update the firmware using OvrC if a new version is available (300/500/700 models only).
Internet
Web Browser
Access
Mobile Apps
Web Interface / Utility
Router
WB-700-IPV-12
OvrC Server
2. Install the WattBox IP Utility Software
Download
the WattBox
Utility from the Product page on the SnapAV website
(utility is not Mac-compatible) and install the
software.
Search “WattBox” in the Start menu
search bar to find the installed utility.
