Snap-On Zeus, Руководство пользователя

Страница: 141 / 235

Scope and Multimeter Operations Ignition Scope
134
Waste Spark
Waste Spark is used for coil pack systems that fire two plugs simultaneously.
1. Enter the Number of Cylinders .
2. Select the Firing Order .
3. Check the engine firing polarity and change the Polarity setting to match it by
using the + and - buttons.
Setup Notes:
–
Connect the #1 trigger lead to cylinder #1.
–
To test a single coil, set the number of cylinders to 2.
–
When testing Wasted Spark systems, power firings will display on Channel
One and waste firings on Channel Two.
4. Refer to the following sections for additional ignition scope settings:
– Traces (Ignition Scope Trace Setup) on page 135
–
Sweep (Ignition Scope Sweep Setup) on page 136
– Trigger (Ignition Scope) on page 137
For common settings within the Preferences menu, see
Setup Menu (Preferences)
on page 108
.
Figure 9-61
Direct Ignition
Direct is used for coil-on-plug systems.
1. Enter the Number of Cylinders .
2. Select the Firing Order .
Setup Notes:
–
Plug is preset as the setting for Number 1 Trigger setting.
–
Connect the #1 trigger lead to cylinder #1. (For vehicles without a plug wire,
this connection may not be possible. As an alternate method that may work,
try clamping around the #1 cylinder primary coil driver wire or all primary
wires if they are tightly bundled.)
3. Refer to the following sections for additional ignition scope settings:
– Traces (Ignition Scope Trace Setup) on page 135
–
Sweep (Ignition Scope Sweep Setup) on page 136
– Trigger (Ignition Scope) on page 137
For common settings within the Preferences menu, see
Setup Menu (Preferences)
on page 108
.
Figure 9-62