Snap-On Vantage Legend, Руководство пользователя

Страница: 81 / 86

Maintenance Battery Pack Service
73
Electric shock can cause injury.
Risk of explosion.
• The Lithium battery is factory replaceable only, incorrect replacement or
tampering with the battery pack may cause an explosion.
Explosion can cause death or serious injury.
IMPORTANT
The battery pack contains no user serviceable components. Tampering
with the battery pack terminals or housing will void the product warranty.
Keep the following in mind when using and handling the battery pack:
•
Do not short circuit battery pack terminals.
•
Do not immerse the diagnostic tool or battery pack in water, or allow water to
enter the diagnostic tool or battery pack.
•
Do not crush, disassemble, or tamper with the battery pack.
•
Do not heat the battery pack to over 100°C (212°F), or dispose of it in a fire.
•
Do not expose the battery pack to excessive physical shock or vibration.
•
Keep the battery pack out of reach of children.
•
Do not use a battery pack that appears to have suffered abuse or damage.
•
Charge the battery pack in the appropriate charger only.
•
Do not use a battery charger that has been modified or damaged.
•
Use the battery pack for the specified product only.
•
Store the battery pack in a cool, dry, well ventilated area.
NOTE
The battery pack should be used within a short period of time (about 30 days)
after charging to prevent loss of capacity due to self-discharging.
If long-term storage of the battery pack is necessary, it should be stored in a in a
cool, dry, well ventilated place with a 30 to 75 percent state of charge to prevent loss
of characteristics.
To prolong the life of your battery, turn off the diagnostic tool when not in use. The
diagnostic tool has a built in charger that recharges the battery on demand
whenever it is connected to a power source.
8.2.2 Ordering a New Battery Pack
If the battery pack needs to be replaced, contact your sales representative to order
a new battery pack.
IMPORTANT
Only use the recommended Snap-on replacement battery pack.
8.2.3 Replacing the Battery Pack
If the battery pack no longer holds a charge, contact your sales representative to
order a new one.
IMPORTANT
Replace the battery pack with original Snap-on replacement parts only.
z
To replace the battery pack:
1. Loosen the two captive screws that retain the battery compartment cover on the
back-side of the Diagnostic Tool (
Figure 8-1
).
2. Pull up on the inner edge of the battery compartment cover to release it, pivot the
cover into an upright position, then lift the battery cover off of the housing.
3. Slide the battery down to disengage the electrical contacts.
4. Remove the battery from the tool housing.
5. Align the tabs on the sides of the battery compartment with the slots on the new
battery, then place the battery into the housing.
6. Slide the battery up to engage the electrical contacts and snap it into place.
7. Fit the battery cover onto on the housing, then pivot the cover down so that it
snaps into place.
8. Snug up the captive screws to hold the cover in place.
Do not overtighten the
screws!
WARN ING